RADEMACHER RolloPort S2 Bedienungsanleitung Seite 43
Quelle: rademacher.de
Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
(A) Installation of the header bracket (1)
NOTE
The header bracket (1) must be aligned with the mid-
point of the door.
1.
Mark out the position of the header bra-
cket (1) and drill the mounting holes (e.g.
with a 10 mm masonry drill bit).
2.
Screw the header bracket (1) tight with
the enclosed hexagon screws (8 x 60 mm).
3.
Then fix the rail (4) with the enclosed
hexagon screw (6 x 80 mm) to the header
bracket (1).
(B) Installation of the fixing bracket (5) at the door operator head (7)
1.
Push the fixing bracket (5) onto the rail
(4), as close to the door operator head
(7) as possible.
2.
Mark the mounting holes for the fixing
bracket (5).
In order to do so, lift the entire construction and push
it against the ceiling.
NOTE
Ensure that the rail (4)
the door.
3.
Drill the mounting holes (e.g. with a 10
mm masonry drill bit).
4.
Finally screw the fixing bracket (5) to the
garage ceiling with the enclosed hexagon
screws (8 x 60 mm).
(4)
(4)
(4) is aligned with the centre of
(4)
2
1
Key
1
= Header bracket
2
= Screw (6 x 80 mm) with hexagon nut
3
= Hexagon screw (8 x 60 mm)
4
= Rail
4
5
6
7
Key
4
= Rail
5
= Fixing bracket
6
= Hexagon screw (8 x 60 mm)
7
= Door operator head
GB
3
4
43
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
