Assembly of the rails
NOTE
The RolloPort S2 is supplied with three rails:
◆ two end pieces, including a pre-assembled chain
◆ a middle piece (without a chain) with two connectors
Lay the two end pieces with the pre-
1.
assembled chain on the ground, with the
chain lying as straight as possible be-
tween the two end pieces.
2.
Push the two enclosed connectors onto the
middle piece and then lay the middle piece
in the gap between the two end pieces.
3.
Insert the chain into the middle piece.
4.
Push each of the connectors onto the join
between the middle piece and each of the
end pieces.
Please ensure that each of the connectors lies in the
centre between the fixing plates of the rail underside.
5.
Finally, bend the fixing plates outwards
with a small screwdriver.
As a result, the connectors can no longer be moved.
Tension the drive chain
1.
Screw the clamping nut tight with a
suitable socket key (∅ ∅ ∅ ∅ ∅ 10 mm).
2.
Adjust the tension of the chain as shown
in the picture.
40
Connector 1
1.
2.
GB
Connector 2
Fixing plates
1
2
3