RADEMACHER RolloPort S2 Bedienungsanleitung Seite 48

Carry out reference run for power measurement
During the reference run there is a risk of
injury, as the door operator develops
extremely strong forces.
1. Press „+", the
display shows „3".
4. After it has stopped,
press the „P" button
twice.
7. Conclude the pro-
gramming (refer to
page 53, method 1).
48
2. Press „P",
„3" flashes.
5. The door goes down.
IMPORTANT
Once you have set the two limits and the reference run for power measurement,
you have fulfilled the basic settings required for safe operation.
If you do not require any further settings, you must conclude programming as
specified in method 1 on page 53, in order to adopt the basic settings you have
just programmed. -
After this, you can conclude the following individual settings, either singly or after
all the settings have been programmed, using method 2 on page 53.
3. The door goes up
automatically.
6. After it has stopped, press
„P", to store the infor-
mation.
GB