General Safety Instructions - Ottobock BionicLink 60X7 Gebrauchsanweisung

Patient-specific adjustments can therefore be carried out without a cable connection, and the
patient has more freedom of movement during the adjustment process. The BionicLink must be
removed from the patient's leg orthosis following adjustment.
The BionicLink is suitable for patients with a left-sided or right-sided fitting.
INFORMATION
The 60X7 BionicLink does not require any batteries for operation, as it is powered by the battery
of the C-Brace orthosis.
2.1 Combination possibilities
• 4X183 wireless adapter cable BionicLink C-Brace
3 Application
3.1 Indications for use
The product is to be used exclusively for data communication for adjusting a C-Brace orthosis.
3.2 Conditions of use
The fitting of a patient with the product may only be carried out by an orthopaedic technician.
4 Safety
4.1 Explanation of warning symbols
NOTICE Warning regarding possible technical damage.
4.2 Structure of the safety instructions
CAUTION
The heading describes the source and/or the type of hazard
The introduction describes the consequences in case of failure to observe the safety instruc­
tions. Consequences are presented as follows if more than one consequence is possible:
> E.g.: Consequence 1 in case of failure to observe the hazard
> E.g.: Consequence 2 in case of failure to observe the hazard
This symbol identifies activities/actions that must be observed/carried out in order to avert
►
the hazard.

4.3 General safety instructions

NOTICE
Use by untrained personnel
Limited function due to product malfunction or damage.
► The product may only be used by trained orthopaedic technicians.
NOTICE
Penetration of dirt and humidity into the product
Limited function due to product malfunction or damage.
Ensure that neither solid particles nor liquids can penetrate into the product.
►
► If liquid has penetrated into the product, forward it to an authorised Ottobock Service
Centre before using it again.
Ottobock | 13