Additional Programming Sequence - Dascom Tally T2150S Kurzanleitung

Cutter-en.book Seite 16 Donnerstag, 3. Mai 2007 9:42 09

Additional programming sequence

Additional programming sequence
16
Downloaded from www.Manualslib.com
With the cut device installed, an escape sequence for cutting at the current line is
available in addition to the programming sequences described in the optionally
available Programming Manual.
Data structure
ASCII ESC
hex 1B
dec. 27
Parameters
For the ESC [ n { function, the following parameters are available for n:
n
0
5
6
7
22
50
51
54
* Above the line if the text to be printed ends with a CR (hex. 0D, dec. 13).
Below the line if the text to be printed ends with a LF (hex. 0A, dec. 10).
Cutting single sheets is not possible. Refer to the programming manuals for more
details on the programming sequences.
manuals search engine
,,[ <n> ,,{
5B n 7B
91 n 123
hex. dez. Paper source and cut
30 48 Single sheet (manually)
35 53 Fanfold paper tractor 1
36 54 Fanfold paper tractor 2
37 55 Fanfold paper tractor 3
32 32 50 50 Fanfold paper ASF-F
35 30 53 48 Return sheet to the printing position
35 31 53 49 Cut fanfold paper at next perforation
35 34 53 52 Cut above/below the current line*
Quick start guide