Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Cutter-en.book Seite 14 Donnerstag, 3. Mai 2007 9:42 09
Handling and settings
Sync.Label=Off *
Set
<
>
1
2
3
14
Downloaded from
www.Manualslib.com
Press the < (2) or > (3) key to switch the parameter to On. Confirm the setting by
pressing the Set (1) key.
Online
Exit
4
Setup
If you use paper without the required label on the back after activating the param-
eter Sync.Label, an error message Load error appears in the display, printing is
not possible.
If the printer cannot detect an existing label on the back of the paper, the param-
eter Pap.back can in test mode be set from "normal" to "dark". You will find a
description of this parameter in the user guide of your printer on the online CD-
ROM.
You must deactivate this parameter before removing the cut device. It only appears
STOP
in the test menu when the cut device is installed and therefore cannot be switched
off after removing the cut device, but remains active.
manuals search engine
Quick start guide
Werbung
Kapitel
Inhaltsverzeichnis
