PeakTech 4955 Bedienungsanleitung Seite 48

Emissivity
Alarm High
Alarm Tief
Laser
Auto mode
Max/Min
Average/Dif.
Ambient Temp.
%RH
Dewpoint/Wetblub
Type-K
Set the emissivity factor value manually
from 0.01 up to 1.00 depending on the
measured surface character
Set the high- temperature value for setting
off an acoustic and optical Alarm
Set the low- temperature value for setting
off an acoustic and optical Alarm
Switch ON- or OFF the dual target laser
Set if the trigger must be pressed for
measurement or if the device makes
automatic measurement
Enable/Disable
maximum(MAX)
measurement values
Enable/Disable the display of the average
value(AVG)
measurement
minimum and maximum measurement
values
Enable/Disable the display of the ambient
air temperature value (AT) and the relative
humidity (RH) in %
Enable/Disable the display of the dewpoint
temperature
temperature (WB)
Enable/Disable the display of the Type-K
temperature probe
-47-
the display
or minimum
or the
value (DIF)
(DP) or the
of the
(MIN)
differential
from the
wetbulb