bürkert 8232 Bedienungsanleitung Seite 15

Type 8232
Installationandwiring
566051
Versions with the internal holder:
1.
Carefully fill up the internal holder with the electrolyte.
2.
Check there is no air (bubbles) in the internal holder, else do the
—
filling again.
3.
Hold the shaft upright and push the working electrode carefully into
the filled internal holder.
—
4.
Check if air bubbles are visible in the specific membrane of the
internal holder.
5.
If there are air bubbles, remove the internal holder from the shaft if
needed, rinse it carefully with clean water and dry the specific mem-
—
brane with an absorbant paper towel.
6.
Repeat instructions 1 to 5 until there are no more air bubbles in the
internal holder.
Instructions 566052 & 565164
english
13