Start-up: Control box, power supply, receiver and remote control
The following electrical parts accompany this gas fireplace:
Control box for LED
light
Connection of control box for LED light
The control box is positioned behind the inspection
hatch.
The grey control box must be connected to the
power supply, as shown in the image.
NB!
The power supply (12 V adapter) may not be directly connected to the receiver, otherwise this
could lead to overheating and functional failure.
Connection of receiver
The wide yellow/blue/ green connector on the
control box must be inserted in the receiver, as
shown in the image.
NB: If there is a power failure, four AA batteries can
be fitted in the receiver. If batteries are used in the
receiver, the LED light and MyFire wi-fi-box will not
operate.
INSTALLATION MANUAL
Power supply/adapter
Receiver
Remote control
GB - 46