Remote Control; Inserting Batteries In The Remote Control; Synchronisation Of The Remote Control And Receiver - attika VISIO GAS serie Installationsanleitung

INSTALLATION MANUAL

Remote control

In this section you can learn how to set up the remote control for the gas fireplace.

Inserting batteries in the remote control

The remote control uses 2 x AAA 1.5 V batteries.
When using the fireplace for the first time in the year, you should
replace the batteries.
Replace all of the batteries at the same time. Use only good quality
alkaline batteries.
Never use pointed tools to remove the batteries from the box.

Synchronisation of the remote control and receiver

You must first synchronise the remote control and fireplace receiver in order for the remote control
to function. Procedure to synchronise the remote
control and receiver:
Open the inspection hatch by lightly pressing it.
Press and hold in the receiver "reset" button until
you hear short 'beep' followed by a long 'beep'.
Release the button.
You now have 11 seconds to press the arrow down button on the remote control. Hold the button in
until you hear a short "beep" from the receiver. You will know see the world "conn" on the remote
control.
The receiver and remote control are now synchronised.
47 - GB