Unpacking; Installing The Unit - Daikin KHRQ23M29H Installationsanleitung

8.3. Unpacking

CAUTION
To avoid injury, do not touch the air inlet or aluminium fins
of the unit.
Relief the unit from its packing material:
Take care not to damage the unit when removing the shrink foil with a
cutter.
WARNING
Tear apart and throw away plastic packaging bags so that
children will not play with them. Children playing with
plastic bags face danger of death by suffocation.
Remove the 4 bolts fixing the unit to its pallet.
Make sure that all
"4.1. Accessories supplied with this unit" on page 4 are available
in the unit.
REYAQ10~16P7Y1B
VRVIII system outdoor unit
4PW62582-1A – 08.2011
accessories as mentioned

8.4. Installing the unit

Make sure the unit is installed level on a sufficiently strong base
to prevent vibration and noise.
NOTICE
When the installation height of the unit needs to be
increased, do not use stands to only support the corners:
The height of the foundation must at least be 150 mm from the
floor.
In heavy snowfall areas, this height should be increased
dependant on the installation place and condition.
The unit must be installed on a solid longitudinal foundation
(steelbeam frame or concrete) and make sure the base under
the unit is larger than the grey marked area:
1300
1162
1 Hole for foundation bolt
2 Inner dimension of the base
3 Distance between foundation bolt holes
4 Depth of unit
5 Outher dimension of the base
6 Longitudinal foundation dimension
7 Distance between foundation bolt holes
(distances shown are in mm)
Fasten the unit in place using four
foundation bolts M12. It is best to screw in
the foundation bolts until their length
remains 20 mm above the foundation
surface.
in
NOTICE
Prepare a water drainage channel around the
foundation to drain waste water from around the unit.
During heating operation and when the outdoor
temperatures are negative, the drained water from the
outdoor unit will freeze up. If the water drainage is not
taken care of, the area around the unit might be very
slippery.
When installed in a corrosive
environment, use a nut with
plastic washer (1) to protect the
nut tightening part from rust.
≥100
X Not allowed
O Allowed (units: mm)
6 7 1 2 3 4 5
Installation manual
≥100
1
10