Beurer BM 77 Gebrauchsanweisung Seite 34

Step 3:
Take a measurement.
Step 4 BM 77:
(Data transfer immediately
following the measure-
ment): If the Bluetooth
®
function has been activated,
the data is transferred after
confirming the user selection
using the START/STOP
button .
Also note the following information:
• Ensure that the "beurer HealthManager" app on your smart-
phone is always activated and launched when you start the
data transfer on the device.
• You can tell that the data transfer is in progress by the Blue­
tooth symbol shown on the display.
®
• If your smartphone has a protective cover, remove it to ensure
that there is no interference during the transfer.
BM 77
Step 4 BM 77:
(Data transfer at a later
point in time): Go into the
memory recall mode for the
desired user memory (see
"Saving, accessing and
deleting measured values").
The data transfer starts au-
tomatically.
Transfer of measurements via USB
Alternatively, you can also transfer your measured values to
the PC.
To do this, you require a commercially available USB cable
(included in delivery) and the "beurer HealthManager" PC
software. This can be downloaded free of charge from the
download area under Service at www.beurer.com.
System requirements for the „ beurer HealthManager" PC
software
– from Windows 8.1
– from USB 2.0 (Type-A)
To transfer the measured values, proceed as follows::
• Connect your blood pressure monitor to your PC using the
USB cable provided. Please note that you cannot start a data
transfer to the PC whilst a measurement is being taken.
• PC is shown on the display. Begin the data
transfer
in the " beurer HealthManager" PC software.
• During the data transfer, an animation is shown on
the display. A successful data transfer is displayed
as in figure 1. If the data transfer is unsuccessful,
an error message appears as in figure 2. In this
case, interrupt the PC connection and start the
data transfer again.
• After 30 seconds of not being in use or if commu-
nication with the PC is interrupted, the blood pres-
sure monitor switches itself off automatically.
34
figure 1
figure 2