Christopeit EL 8 - 9824 Montageanleitung Und Bedienungsanleitung Seite 19

Step 4:
Installation of the small handle bar (43) with small handlebar bra-
cket (44)
on handlebar post (15).
1. Place the small handlebar bracket (44) on the small handle bar (43)
in such a manner that the bores in the bracket and those at the end
of the handlebar are aligned.
2. Place the whole assembly against the upper end of the handlebar
post (15) through the thread bolts and tighten it with washer (45)
spring washer (32) and self lock nut (46) firmly.
(Note: The handle bar must be aligned so that it is inclined away
from the handlebar post (15).)
3. Put into the each end of small handlebar (43) one end cap (47).
Step 5:
Installation of the right and left pedal tube (21+24) with swivel tube
(26)
on the left and right handle bar (18+20) and cross frames (22+104).
1. Push the end of the right pedal tube (24) onto the cross frame (22)
and tighten it with screw (23), washer (16) and spring washer (6) at
the cross frame (22) firmly.
2. Push the swivel tube (26) into the right handle bar (20) and tighten it
with screws (12), spring washer (6) and washer (27) firmly.
3. Install the left pedal tube (21) with all additionally required parts on
the left hand side of the machine as described in 1. + 2.
Step 6:
Installation of the front and rear pedal cover (35, 36+39) on the
pedal tubes (21+24).
1. Push the rear pedal tube cover (39) onto the connection point of
cross frame (22+104) and pedal tube (21+24) and fasten it with
screw (37).
2. Put each one of left and right pedal front cover (35+36) onto one
connection point of swivel tube (26) and pedal tubes (21+24) together
and fasten them with screws (37+38).
19