Switching off:
Locking:
Releasing the lock:
Attention: Wait until the electric motor has come to a complete standstill before you engage the
spindle lock.
Setting the speed
You can set the required speed / rpm using the speed control wheel
You can also change the speed whilst you are working. A practical test before you start can help
you to determine the most appropriate speed to use.
To increase the speed (rotation), turn the speed control wheel
To decrease the speed (rotation), turn the speed control wheel
Changing the grinding disc
Note: Only use discs that are free of contaminants, as indicated in "Important safety advice".
Isolate the tool from the electrical power supply by pulling the plug from the socket.
Always wear protective gloves when changing a grinding or cutting disc.
Press the spindle lock
Once the grinding disc has been changed retighten the clamping nut .
Warning: If after replacement, the grinding disc runs erratically or vibrates, it must be changed
immediately.
Grinding discs
The following grinding discs can be fitted to this angle grinder:
· Grinding discs, glass fibre reinforced for grinding, dimensions: ø 125x22.5x6 (6=thickness)
· Grinding discs, glass fibre reinforced for cutting, dimensions:
If you use normal grinding discs, you should always choose glass fibre reinforced types.
Standards
for grinding discs / grinding equipment:
Release the ON/OFF switch
Keep the ON/OFF switch
Press the ON/OFF switch
to block the drive. Remove the clamping nut
again
pressed and press the locking button
again
to suit your work.
towards 6 (6 = highest speed).
towards 1 (1 = lowest speed).
using the wrench .
ø 125x22.5x6 (3=thickness)
DIN ISO 603-14
DIN ISO 603-16
Operation
GB 17
PARKSIDE