Safety; Important Safety Advice - Parkside PWS 1200 Bedienungs- Und Sicherheitshinweise

Safety

The PWS 1200 angle grinder has INTELLIGENT POWER CONTROL.
This electronic management system monitors and controls your angle grinder in its
various operating states;
Operating state
Switching On:
No-load running:
Load / overload operation:
The IPC electronic management system has several modes of operation. These modes are designed
to get the best out of the grinder and allow you to work in a safe and efficient manner. Heavy
transient current surges and the resulting tiresome tripping of safety cut-out devices are largely
avoided. The speed controller ensures a relatively low constant no-load speed and with this a long
operating life for your grinder. By making these quick re-adjustments, the IPC electronic management
system ensures - even during the work and under rapidly changing load conditions - that you always
have the perfect grinder performance at your disposal. The overload control constantly checks and
monitors the output of the tool during the work. The tool limits the overload to a maximum value by
switching off.

Important safety advice

The following safety advice must be always observed when using electrical equipment:
This advice will help you avoid serious injury or damage and achieve better results from your work.
Please read carefully through the following information concerning safety and proper use. Before
reading, fold out the page with the illustrations and make yourself familiar with all the functions of
the device. Be careful to keep these advice notes and if necessary give or loan them with the machine
to a third party.
To avoid danger to life from electric shock:
· Do not operate the device if the mains lead or the mains socket is damaged.
Caution! Damaged mains leads present a serious danger to life through electric shock. If the device
14 GB
PARKSIDE
Feature
The IPC electronic system start-up mode ensures that the motor
starts up slowly and gently. This largely
avoids heavy transient current surges, and means that electrical
safety cut-out devices are not
generally tripped (building sites, domestic premises).
After switching on, the IPC electronic system run-up mode takes
the grinder's speed up to the pre-set
required value (Setting 1 ... 6). After this is reached, the IPC
system speed control mode keeps
the grinder operating at a constant speed.
Load / overload operation: The tool has a preset overload limit.
If this is exceeded; the operating current is limited, the tool
switches off and prevents the motor from burning out.