Original Ancillaries / And Accessories; Operation; Switching On And Off; Setting The Oscillation Speed - Parkside XQ310 Bedienungs- Und Sicherheitshinweise

General safety advice / Operation
Original ancillaries / and
Q
accessories
J
Only use accessories and tools that are specified
in the operating instructions. The use of tools
and accessories other than those recommended
in the operating instructions could lead to an
increased risk of personal injury for you.

Operation

Q
Operation
Q
Take note of the mains voltage! The voltage must
agree with the information on the type plate of the
appliance (appliances that are designated as 230 V
can also be connected to 220 V).

Switching On and Off

Q
Switching on intermittent function:
j
Press the ON / OFF switch
Switching off intermittent function:
j
Release the ON / OFF switch
Switching on continuous operation :
j
Press the ON / OFF switch
and press the locking button
Switching off continuous operation:
j
Press the ON / OFF switch
again.

Setting the oscillation speed

Q
You can set the desired oscillation speed as
needed with the oscillation speed selector
The required oscillation speed depends on the
material being worked and can be determined
through practical tests.
10 GB/IE/CY
E-23503_XQ310_Content_LB3.indd 10
Q
appliance, always disconnect the power.
Note: Before attaching a new sanding pad
remove dust and dirt from the sanding plate
1. Open the two tensioning levers
2. Slide the sanding pad
3. Do the same at the other end. Make certain
4. IMPOrTaNT! To ensure that vacuuming of
Various materials require different grit values. You
1
.
can read which grit value is best suited for which
work in our recommendations under "Tips and tricks".
1
.
Q
, hold it pressed
1
2
.
then release it collection box
1
cleaner via an external suction adapter! Under
unfavourable conditions, such as flying sparks,
grinding of metal or metal remnants in wood, the
wood dust in the dust sack (or in the dust bag of
a vacuum cleaner) can ignite. This can happen
especially if the wood dust has paint particles on
. it or is mixed with other chemical substances and
10
the sanded material is hot after extensive working.
You should therefore avoid overheating of products
being sanded as well as the appliance and always
empty the dust collection box
of the vacuum cleaner before work pauses.

attaching a sanding pad

WarNING!
Before performing work on the
them up to clamp in a new sanding pad
when switching the sanding pads
use with different material.
9
clamping bar above the sanding plate
6
and clamp it tightly by pressing the tensioning
lever back down.
7
that the sanding pad 9 rests firmly against the
sanding plate . See also Fig. B and C.
8
dust through the sanding plate
the holes in the sanding pad
ing plate must match up.
8

Vacuuming dust

WarNING!
A risk of fire exists when working with
electrical appliances that have a dust
or can be attached to a vacuum
4
,
9
.
8
by pushing
7
or
9
for the
9
at one end under the
8
is guaranteed,
8
and the sand-
9
FIrE HazarD!
4 or the dust bag
21.07.2008 16:26:29 Uhr