Inserting / Removing The Battery Pack Into / Out Of The Drill / Grinder; Changing A Collet; Inserting / Changing Tools; Switching On And Off / Setting The Speed Range - Parkside PFBS 9,6 V Bedienungs- Und Sicherheitshinweise

J
Switch the charger off for at least 15 minutes
between successive charging processes. To do
this pull the mains plug (mains adapter
of the socket.
Inserting / removing the
Q
battery pack into / out of the
drill / grinder
Inserting the battery pack:
j
Set the On / Off switch
j
Insert the battery pack
until it engages.
Removing the battery pack:
j
Pressing the battery pack buttons
sides at the same time allows you to remove
the battery pack

Changing a collet

Q
j
Press the spindle lock
j
Rotate the clamping nut
engages.
j
Release the clamping nut
and remove the collet
j
Insert the correct collet
with the clamping nut
j
Release the spindle lock

Inserting / changing tools

Q
j
Press the spindle lock
j
Rotate the clamping nut
engages.
j
Release the clamping nut
spanner end
j
If a tool is already inserted remove it.
j
First insert the tool you wish to use though the
clamping nut
collet
18
j
Press the spindle lock
j
Insert the collet
screw the clamping nut
Downloaded from www.Manualslib.com
to position "0".
1
into the drill / grinder
3
.
3
and keep it pressed.
7
until the lock
5
from the thread
5
.
18
and screw it tight
18
.
5
.
7
and keep it pressed.
7
until the lock
5
using the open
5
of the combination tool
before you insert it into the
5
.
and keep it pressed.
7
into the threaded insert and
18
tightly on the thread
5
manuals search engine
using the open spanner end
combination tool
) out Note: Use the screwdriver end
9
combination tool
screw of the mandrels
Switching on and off / Setting
Q
the speed range
Switching on / Setting the speed range:
j
Set the On / Off switch
between "2" and "10".
Switching off:
j
Set the On / Off switch
at the
2
Advice on working with
Q
materials / Tools / Speed ranges
j
Make sure that no debris from working the
material adheres to the tool. Use paraffin, cut-
ting oil or similar medium to lubricate the tool.
j
Use the highest speed when working on steel
or iron with the milling bits.
j
Use a short trial on a test piece to determine the
optimum rotational speed range for working on
zinc, zinc alloy, aluminium, copper and lead.
j
Use the low speed range for working on plas-
tics and low-melting point materials.
j
Use high speeds on wood.
j
Use the medium speed range for cleaning,
polishing and buffing.
The following information shall be considered as
recommendatory only. Learn by practical experi-
ence which tools and settings are the best for the
materials you work with.
.
23
Operation
of the
.
23
of the
to release or tighten the
23
.
12
to a position
1
to position "0".
1
GB 9