Scope Of Delivery; Instructions For Use; Preparation For Use - Ottobock Liner Gebrauchsanweisung

► The product may be used by one person only.
► Clean the product regularly.
CAUTION
Incorrect or excessively tight application of the product to the
body
Risk of pressure points and constriction of blood vessels and nerves
due to improper application
► Ensure that the product is applied properly and fits correctly.
► Do not continue to use the product if there are problems with the
correct fit.
CAUTION
Use of the product on damaged skin
Skin irritation, formation of eczema or infections due to contamina­
tion with germs
► Only use the product on healthy skin.

4 Scope of delivery

Quantity Designation
1

Instructions for use

1 Liner

5 Preparation for use

The following technical information is available if needed:
Uneo liner
8
5.1 Size selection (standard liner only)
INFORMATION
Be sure to select the correct liner size. Possible problems are listed
below.
► Liner too small: Feelings of numbness, formation of blisters,
pistoning in the prosthetic socket
► Liner too large: Increased perspiration, rotation of the residual
limb in the liner, formation of blisters, skin rash
1) TF liner: Measure the residual limb circumference5 cm proximal
of the residual limb end.
TT liner: Measure the residual limb circumference 4 cm proximal
of the residual limb end.
2) Only with 6Y510, 6Y512: Measure the residual limb length from
the MPT point (mid-patella-tendon) to the end of the residual limb.
3) CAUTION! Reduce by a maximum of 1 liner size to avoid
excessive compression.
Select the liner size that corresponds to the resulting measure­
ment. Alternatively the next smaller size can be chosen.
4) Check the fit of the liner.
Reference
5.2 Adapting the liner
number
Recommended tools for liners with textile cover: 719S7 trim­
>
–
ming scissors, 719S20 scissors for synthetic fibres or convention­
–
al straight edge scissors
Recommended tools for liners without textile cover: 756L9
>
trimming device, 756L10 liner trimmer or conventional straight
edge scissors
► NOTICE! Do not use wave edge scissors.
646T2=1.8
TT liner: Cut the liner horizontally at the required length. Make
sure a smooth cutting edge is obtained to prevent the material
from tearing.
TF liner: Cut the liner according to the trim line. The liner always
has to end outside the prosthetic socket.