Cleaning Instructions; Accessories; Transport And Storage; Service And Repair - RIDGID SeeSnake microDrain Bedienungsanleitung

Cleaning Instructions

WARNING
Make sure that the system cable is disconnected
from the CCU prior to cleaning to reduce the risk
of electrical shock.
Clean the microEXPLORER Camera monitor or CCU
as per its operators manual. Prior to cleaning the
microDrain, remove the microEXPLORER Camera mon-
itor from the display cradle. Do not allow the
microEXPLORER Camera monitor or CCU to get wet
during cleaning.
The microDrain System can be cleaned by wiping with a
soft, damp cloth. Do not use any solvents to clean the
microDrain System. They can damage the unit. If de-
sired, a disinfectant can be used on the microDrain
System.
The drum and cable may be removed and the interior of
the drum cleaned with a hose or pressure wash. The
outside of the drum can be cleaned by wiping with a soft,
damp cloth. Avoid hosing the contact board on the back
of the drum.

Accessories

WARNING
The following accessories have been designed to
function with the microDrain System. Other ac-
cessories suitable for use with other equipment
may become hazardous when used with the
microDrain System. To reduce the risk of serious in-
jury, only use accessories specifically designed
and recommended for use with the microDrain
System, such as those listed below.
Catalog # Description
33108 microDrain System Slip-Ring Module
(for SeeSnake)
33113 microDrain System Slip-Ring Module
(for microEXPLORER Camera Monitor)
Various RIDGID SeekTech
Locators
Various RIDGID SeekTech
Transmitters
Various RIDGID SeeSnake Camera Control Units
34318 microDrain Ball Guides
SeeSnake
® or NaviTrack ®
® or NaviTrack ®
Ridge Tool Company
® microDrain™ Inspection System

Transport and Storage

Do not expose to heavy shocks or impacts during trans-
port. Store in environments within temperature range of
-4°F to 158°F (-20°C to. 70°C).

Service and Repair

WARNING
Improper service or repair can make the microDrain
unsafe to operate.
Service and repair of the microDrain System must be
performed by a RIDGID Independent Authorized Service
Center.
For information on your nearest RIDGID Independent
Service Center or any service or repair questions:
• Contact your local RIDGID distributor.
• Visit www.RIDGID.com or www.RIDGID.eu to find
your local Ridge Tool contact point.
• Contact Ridge Tool Technical Services Department at
techservices@ridgid.com, or in the U.S. and Canada
call (800) 519-3456.

Disposal

Parts of the microDrain System contain valuable mate-
rials and can be recycled. There are companies that spe-
cialize in recycling that may be found locally. Dispose of
the components in compliance with all applicable regu-
lations. Contact your local waste management authority
for more information.
Do not dispose of electrical equipment
with household waste!
According to the European Guideline
2002/96/EC for Waste Electrical and
Electronic Equipment and its implemen-
tation into national legislation, electrical
equipment that is no longer usable must be collected
separately and disposed of in an environmentally correct
manner.
13