Charging Procedure/Operating Instructions; Cleaning Instructions; Accessories; Storage - RIDGID micro CA-300 Bedienungsanleitung

Charging
Procedure/Operating
Instructions
WARNING
Always wear eye protection to protect
your eyes against dirt and other foreign
objects.
Follow operating instructions to reduce
the risk of injury from electrical shock.
NOTE! New batteries reach their full capacity
after approximately 5 charging and dis-
charging cycles.
1. Set up charger according to the Charger
Inspection and Set Up section.
2. The charger conducts a 1-second life
test during which the LED blinks from
red to green. The charger then goes into
standby mode in which the LED is OFF.
3. With dry hands, insert the battery pack
onto the charger. The battery pack will
begin charging automatically. While the
battery is charging, the red LED will glow
solid.
4. When the battery is fully charged, the
green LED glows solid. Remove the bat-
tery. Once the battery is charged, it may
remain on the charger until it is ready to
be used. There is no risk of over-charging
the battery. When the battery has been
fully charged, the charger automatically
switches to retention charging.
5. With dry hands, unplug the charger from
the outlet once charging is complete.

Cleaning Instructions

WARNING
Unplug the charger before cleaning. Do
not use any water or chemicals to clean
charger or batteries to reduce the risk of
electrical shock.
1. If present, remove battery from charger.
2. Remove any dirt or grease from the ex -
terior of the charger and battery with a
cloth or soft non-metallic brush.
micro CA-300 Inspection Camera

Accessories

WARNING
To reduce the risk of serious injury, only
use accessories specifically designed
and recommended for use with the
RIDGID Li-Ion Battery Charger such as
those listed below. Other Accessories
suitable for use with other tools may
be hazardous when used with the
RIDGID Li-Ion Battery Charger.
Catalog
No. Description
37088 micro CA-300 Charger
37083 micro CA-300 3.7V Li-Ion Battery
30758 microEXPLORER Charger
30198 microEXPLORER 3.7V Li-Ion
Battery
Further information on accessories specific
to the charger can be found in the RIDGID
Catalog and online at www.RIDGID.com or
www.RIDGID.eu.

Storage

Store the charger and the batteries in a dry,
secured, locked area that is out of reach of
children and people not familiar with proper
charger operation.
The batteries and charger should be pro-
tected against hard impacts, moisture and
humidity, dust and dirt, extreme high and low
temperatures and chemical solutions and va-
pors.
Long-term storage in temperatures above
104°F (40°C) can permanently reduce the
capacity of the batteries.

Service and Repair

WARNING
Improper service or repair can make the
RIDGID micro CA-300 Inspection Camera
unsafe to operate.
There are no user-serviceable parts for this
charger or batteries. Do not attempt to open
charger or battery cases, charge individual
battery cells or clean internal components.
Service and repair of the charger must be
performed by a RIDGID Independent Author -
ized Service Center.
17