Preparing the positioner
1. You have performed the steps described in the section "Auto-Hotspot".
2. Unplug the ribbon cable connector
3. Remove the basic electronics
the pneumatic block.
⑥
4. Loosen screw
in the connection area of the positioner.
5. Insert the connector of the ribbon cable (A) into the slot as shown below.
Note: There is no space for the ribbon cable (A) in earlier versions of the positioner. Here you fasten the ribbon cable
with the supplied cable tie at the container.
6. Secure the EMC filter module using the screw
7. Fit the basic electronics
8. Insert the ribbon cable connector
9. In non-hazardous environment:
–
Stick the supplied nameplate over the nameplate on the external position detection system
–
Replace the blue cable gland
Refer to section "Auto-Hotspot", items "Nameplate for device version without explosion protection" and "Gray cable gland".
For further information on fitting of an option module, refer to the operating instructions of the respective positioner version in
section "Installing/mounting > Installing option modules".
Procedure for connecting an external position detection system
1. Connect the three terminals of the external position detection system
①
using a cable as shown in the wiring diagram.
2. Tighten the cable glands
22
④
to the fitted potentiometer from the basic electronics
⑤
from the positioner. To this end, remove the two screws that fix the basic electronics to
⑥
⑤
back into the positioner.
④
of the EMC filter module onto the positioner basic electronics.
⑩
by the supplied gray cable gland.
⑩
⑫
and
.
loosened in the third step.
⑨
to the three terminals of the EMC filter module
⑤
.
⑧
.
SIPART PS2 (6DR5...)
A5E03436620-07, 10/2015