Scope Of Delivery; Instructions For Use; Preparation For Use - Ottobock 6A53 Gebrauchsanweisung

4 Scope of delivery

Quantity Designation
1

Instructions for use

1 Adapter
4 Set screw (only 6A54)

5 Preparation for use

CAUTION
Incorrect alignment or assembly
Risk of injury due to damaged prosthetic components
► Observe the alignment and assembly instructions.
CAUTION
Improper assembly of the screw connections
Risk of injury due to breakage or loosening of the screw connec­
tions
► Clean the threads before every installation.
► Apply the specified torque values.
► Follow the instructions regarding the length of the screws and
about how to secure the screws.
5.1 Adjusting adapter
The adapter includes a pyramid adapter adjustable in 2 mm incre­
ments. The pyramid adapter can be aligned proximally or distally.
Required materials: 710D4 torque wrench, 636K13 Loctite 241
>
1) Align the sliding adapter in the desired displacement direction
(a – p or m – l).
2) Lift the ring on the adjustable pyramid adapter slightly in order to
displace the pyramid adapter (see fig. 3).
8
3) Set the desired displacement and press the ring back down until
it engages.
Reference
TIP: Mark the final position with a pen.
number
4) Connect the pyramid adapter with the applicable connecting
–
component (see fig. 4). This fastens the pyramid adapter in its
–
position.
506G3=M8x12
5.2 Connecting the pyramid adapter and pyramid receiver
The pyramid adapter is fixed with the set screws of the pyramid receiv­
er.
Required materials: torque wrench (e.g. 710D20), 636K13 Loc­
>
tite 241
1) Fitting:
Screw in the set screws.
Use the torque wrench to tighten the set screws (10 Nm).
2) Definitive assembly:
Secure the set screws with Loctite.
Screw in the set screws.
Pre-tighten the set screws with the torque wrench (10 Nm) and
then tighten them (15 Nm).
3) Replace any set screws that are protruding or are recessed too
much with appropriate set screws (see selection chart).
Reference number
506G3=M8X12-V
506G3=M8X14
506G3=M8X16
Alignment
The set screws in the pyramid receiver can be used to make static
adjustments during alignment, trial fittings and after the prosthesis is
finished.
Selection table for set screws
Length (mm)
12
14
16