Fitting Or Changing The Cut-Off Wheel; Clamping The Workpiece - struers Discotom-6 Gebrauchsanweisung

Fitting or Changing the
Cut-off Wheel

Clamping the Workpiece

Discotom-6
Instruction Manual
Note: The spindle for Discotom-6 is left-hand threaded. If Discotom-6
has been used for manual cutting, fasten the cutting handle with the
black handle at the right hand side of the machine before changing
the cut-off wheel.

Press and hold down the black locking knob on the right-hand
side of the cut-off wheel, turning the cut-off wheel until the
spindle lock clicks.

Remove the nut with a fork spanner. Remove the flange and the
old cut-off wheel.

Mount the new cut-off wheel.
Conventional cut-off wheels based on Al
between two cardboard washers, to protect the cut-off wheel.
For maximum precision with diamond or CBN cut-off wheels, do not use

Mount the flange and the nut. Tighten carefully and release the
locking knob.

Place the workpiece between the quick clamping devices and
the back stops.

Push the clamps towards the workpiece and lock the quick-
clamping devices with the locking handle.
The workpiece must be firmly held in the quick-clamping devices.

Carefully close the protection guard.
IMPORTANT
O /SiC abrasives should be placed
2 3
cardboard washers.
IMPORTANT
11