Operation; Cleaning And Care; Disposal; Warranty And Service - Parkside PWS A1 Bedienungs- Und Sicherheitshinweise

the workbench / table below the base plate
(see Figure E).
20
Screw the matching mounting bolt
through the front mounting piece
Fasten the front mounting piece
by tightening the corresponding size of nut
on the mounting bolt
9
in the direction of the mounting piece
Now set the adjustment screws
that the angle grinder is aligned at right
angles to the base plate
attached to the mount
After slightly loosening the hexagonal socket
head screws , adjust the saddle
23
that the cutting disc of the angle grinder
lowers into centre of the slot provided in the
base plate .
20
Now attach the safety guard
push the safety guard
rod and fasten it in place with the wing
2
nut (see Fig. C).
4
Now insert the metal rod
sponding opening in the mount
it in place with the wing screw
Always keep the angle grinder's mains lead
in place using the clip
After assembly is complete, switch the angle
grinder on for a few seconds and then
switch it off again. Check again that all the
screws, bolts and fixings are firmly seated.

Operation

Adjust the guide bolts
piece placement.
Place the workpiece on to the base plate
against the rear stop
rotating rotary adjustment knob
Note: Ensure that the workpiece lies
against the base plate
CAUTION! DANGER OF INJURY! En-
sure that the length of the workpiece is at
least half the length of the stop
wise the workpiece may become loose and
slide out.
20 GB/IE
8
.
11
in place
11
(i.e. by turning it
8
).
11
, so
1 13
and firmly
20
(see Fig. E).
24
so
21
. To do this
5
on to the metal
5
into the corre-
2
and fasten
24
(see Fig. C).
27
.
25
for desired work-
16
20
and secure it by
18
.
14
(see Fig. E).
20
, other-
18
Set the vice stops
17
piece lines up with the centre of the cutting
disc.
Now switch on the angle grinder and press
it down on to the workpiece.
Avoid any backwards movement
and apply even pressure on the
workpiece.

Cleaning and care

Use a slightly moist, fluff-free cloth when you
are cleaning or polishing the product.

Disposal

The packaging is made entirely of recyclable
materials, which you may dispose of at local
recycling facilities.
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
product.

Warranty and service

Warranty claim procedure

To ensure quick processing of your case, please
observe the following instructions:
Please have the till receipt and the item number
(e.g. IAN 123456_7890) available as proof of
purchase.
You will find the item number on the type plate,
an engraving on the front page of the instruc-
tions (bottom left), or as a sticker on the rear or
bottom of the appliance.
If functional or other defects occur, please
contact the service department listed either by
telephone or by e-mail.
You can return a defective product to us free of
charge to the service address that will be pro-
vided to you. Ensure that you enclose the proof
, so that the work-
18