Assembly - Parkside PWS A1 Bedienungs- Und Sicherheitshinweise

Use angle grinders that have a cutting disc
diameter of 115 or 125 mm only.
Do not allow anyone else to
come within the working range of
the product while you are using it.
Grip the handle tightly when using the angle
grinder and position your body and arm to
allow you to resist kickback forces.
Do not "jam" the wheel or apply excessive
pressure. Do not attempt to make an exces-
sive depth of cut. Overstressing the wheel
increases the loading and susceptibility to
twisting or binding of the wheel in the cut
and the possibility of kickback or wheel
breakage.
When the wheel is binding or when inter-
rupting a cut for any reason, switch off the
power tool and hold the cutting unit motion-
less until the wheel comes to a complete stop.
Never attempt to remove the wheel from the
cut while the wheel is in motion otherwise
kickback may occur. Investigate and take
corrective action to eliminate the cause of
wheel binding.
Do not restart the cutting operation in the
workpiece. Let the wheel reach full speed
and carefully re-enter the cut. The wheel may
bind, walk up or kickback if the power tool
is restarted in the workpiece.

Assembly

CAUTION! DANGER OF FIRE! Assem-
ble and use the product on a fire-resistant sur-
face only.
Follow these steps:
Fasten the saddle
with the hexagonal socket head screws
20
and washers
23 22
Fasten the handle
with the projecting screw thread and the cor-
responding nut (see Fig. A).
Note: Please bear in mind that the angle
grinder must be fitted with a suitable cutting
disc before assembly. It is not possible to
on to the base plate
21
(see Fig. A).
on to the mount
3 24
change the disc with the angle grinder in-
stalled in the product.
Now prepare for mounting the angle grinder
in the mount .
24
Note: At this point, first check the size of
the handle thread of your angle grinder. It
may be M6, M8 or M10.
Then place the corresponding mounting
bolts , washers and matching nuts
8 7
distance pieces and plastic bushings
10
to one side, ready for use.
Insert the necessary plastic bushings
the mounting pieces
11
Note: Ensure that the size of the plastic
bushings matches the required mounting
6
bolts . Plastic bushings are not required
8
for mounting bolts M10
Screw the matching mounting bolt
through the rear mounting piece
Fig. B).
Fasten the rear mounting piece
by tightening the corresponding size of nut
on the mounting bolt
9
in the direction of the mounting piece
(see Fig. B).
Insert the adjustment screw
bottom hole and the adjustment screw
through the top hole of the mount
Fig. E). Note that later the rubber buffers of
these screws must lie against the angle
grinder housing.
Note: First insert these screws so that the rub-
ber buffers lie directly against the mount
Now push the plastic locating pieces
the mounting pieces
11
of the mount (see Fig. B).
24
Then attach the mounting pieces
through the plastic locating pieces
the hexagonal socket head screws
elongated holes in the mount
Place the desired distance piece
mounting bolt and washer
8
front mounting piece
11
Note: The three distance pieces
choosing the most appropriate cutting depth.
Note: Set the distance piece
cutting disc cannot come into contact with
,
9
6
into
6
, (see Fig. B).
26
.
8
8
(see
26
in place
26
(i.e. by turning it
8
)
26
through the
13
1
(see
24
.
24
of
12
, on to the guide
26
,
11 26
with
12
in the
19
(see Fig. B).
24
on the
10
on to the
7
(see Fig. D).
are for
10
so that the
10
GB/IE 19