Markings For Cutting Line; Connecting The Sawdust Extractor; Changing The Saw Blade; Switching The Laser On And Off - Parkside PTS 710 A2 Originalbetriebsanleitung

Types of saw blades:
The types of saw blades supplied cover the most
common fields of application.
HSS circular saw blade
Description: ø 89 mm, 60 teeth
Suitable for: Softwood and soft metals
HSS circular saw blade
Description: ø 89 mm, 80 teeth
Suitable for: Softwood and soft metals
Diamond-coated cutting saw blade
Description: ø 89 mm
Suitable for: Ceramics and stone
TCT saw blade Z89/30:
Description: ø 89 mm, 30 teeth suitability:
Wood and plastic

Markings for cutting line

The viewing window for the cutting line helps you
accurately guide machine along the cutting line on
the workpiece.
♦ For a true-to-size cut, place the machine onto
the workpiece so that the cut marking appears
in the viewing window for the cutting line

Connecting the sawdust extractor

NOTE
► When working on wood for long periods
of time, and especially when working on
materials that generate dust that is hazardous
to health, connect the unit to an external dust
extraction device suitable for the material.
► Check that the dust extraction unit is correctly
attached.
► Also observe the operating instructions for the
dust extraction device .
► Observe the regulations valid in your country
for the materials to be processed.
♦ Push the suction hose
connection and lock it in place.
♦ Attach an approved dust and sawdust extractor
to the suction hose
PTS 710 A2
Z89/60:
Z89/80:
Z89:
onto the dust extractor
.

Changing the saw blade

WARNING! RISK OF INJURY! Al-
ways remove the plug from the
mains
power socket before carrying out
any work on the appliance.
1. Actuate the spindle lock
key to loosen the tensioning screw
clockwise to open). Now remove the tensioning
screw and the clamping flange
Fig. B).
2. Set the cutting depth to the maximum position.
3. Activate the safety lock-out
that position. Swivel the base plate
4. Remove the saw blade
5. Fit the saw blade in the reverse order as de-
scribed.
6. Press the spindle lock button
es) and use the hex key
sioning screw
■ The arrow on the saw blade must correspond to
the arrow showing the direction of rotation
(running direction shown on the appliance).
Switching the laser on and off
.
Switching on:
♦ Press the Laser ON/OFF switch
Switching off:
♦ Press the Laser ON/OFF switch
NOTE
► If the battery is depleted, replace it with a
new 3 V button cell (type CR 2032).
and use the hex
(see also
and keep it in
upwards.
.
(until it engag-
to tighten the ten-
.
.
again.
GB │ MT │
(turn
67 ■