Inserting/Replacing The Battery; Setting Up; Check Base Plate/Blade Guard; Switching On And Off - Parkside PTS 710 A2 Originalbetriebsanleitung

Inserting/replacing the battery

■ Open the battery compartment cover
Phillips screwdriver.
■ If necessary, remove the used battery.
■ Insert a new 3 V button cell (type CR 2032) in
accordance with the polarity shown. Screw the
lid of the battery compartment cover
on.
CAUTION!
If operating and adjustment equipment is used
or procedures other than those specified here
are carried out, this may result in hazardous
radiation exposure.

Setting up

NOTE
► The appliance is equipped with a Power on/
control lamp . This lights up green as soon
as the appliance is connected to the mains.
This indicates that the appliance is live.

Check base plate/blade guard:

WARNING! RISK OF INJURY! Always
remove the plug from the mains pow-
er socket before carrying out any
work on the appliance.
♦ Check the freedom of movement of the base
plate before each use
♦ Activate the safety lock-out
that position. Lower the circular saw. In this way,
you can test the function of the base plate
must move freely. It may not jam.
♦ After letting go, it must be move smoothly back
to its starting position of its own accord.
│ GB │ MT
■ 66
with a
back
.
and keep it in
. It
Switching on and off
Switching on:
♦ Activate the safety lock-out
that position.
♦ Press the ON/OFF switch
running, you can release the safety lock-out
Switching off:
♦ Release the ON/OFF switch

Selecting the cutting depth

NOTE
► We generally recommend setting the cutting
depth to approx. 2 mm more than the thickness
of the material. This ensures that you achieve
a clean cut.
♦ Let go of the quick-release lever of the cutting
depth preselector
depth on the scale
lever tight again.

Fitting the rip fence

♦ Loosen the screw for the rip fence
base plate . Insert the rip fence
rip fence slot . Retighten the screw for the rip
fence .

Handling the circular saw

1. Place the machine on the material. If necessary,
align the machine with the rip fence
marked line.
2. Activate the safety lock-out
that position. Press the ON/OFF switch
3. Press the appliance forward to lower the circular
saw.
4. Saw by applying moderate pressure.
and keep it in
. Once the saw is
.
. Set the desired cutting
. Clamp the quick-release
on the
into the
or on a
and keep it in
.
PTS 710 A2
.