Power Tool Use And Care; Service; Safety Instructions For Abrasive Cutting Appliances - Parkside PMTS 180 A1 Originalbetriebsanleitung

4. Power tool use and care

a) Do not force the power tool. Use the correct
power tool for your application. The correct
power tool will do the job better and safer at
the rate for which it was designed.
b) Do not use the power tool if the switch does
not turn it on and off. Any power tool that
cannot be controlled with the switch is dangerous
and must be repaired.
c) Disconnect the plug from the power source
and/or remove the battery pack, if detach-
able, from the power tool before making any
adjustments, changing accessories, or storing
power tools. Such preventive safety measures
reduce the risk of starting the power tool acci-
dentally.
d) Store idle power tools out of the reach of
children and do not allow persons unfamiliar
with the power tool or these instructions to
operate the power tool. Power tools are
dangerous in the hands of untrained users.
e) Maintain power tools and accessories. Check
for misalignment or binding of moving parts,
breakage of parts and any other condition
that may affect the power tool's operation.
If damaged, have the power tool repaired
before use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to
control.
g) Use the power tool, accessories and tool bits
etc. in accordance with these instructions,
taking into account the working conditions
and the work to be performed. Use of the
power tool for operations different from those
intended could result in a hazardous situation.
h) Keep handles and grasping surfaces dry,
clean and free from oil and grease. Slippery
handles and grasping surfaces do not allow for
safe handling and control of the tool in unex-
pected situations.
PMTS 180 A1

5. Service

a) Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained.
Safety instructions for
abrasive cutting appliances
1) Safety instructions for abrasive
cutting appliances
a) Ensure that you and everyone else in the
vicinity remain outside of the range of the
rotating grinding disc. The blade guard is
designed to protect the operator from fragments
and accidental contact with the grinding tool.
b) Use only reinforced bonded or diamond-
coated cutting discs for your power tool. Just
because you can attach the accessories to your
power tool does not guarantee they are safe to
use.
c) The permissible speed of the accessory tool
used must be at least as high as the maximum
speed specified for the power tool. Accesso-
ries that rotate faster than the permissible rate
can break and throw pieces into the air.
d) Grinding tools should only be used for the
recommended applications. For example:
Never grind with the side surface of a cutting
disc. Cutting discs are designed to remove
material with the edge of the disc. Any lateral
application of force on these grinding tools can
lead to a breakage.
e) Always use an undamaged clamping flange
of the correct size and shape for the selected
grinding disc. Suitable flanges support the
grinding disc and reduce the risk of disc
breakage.
f) The external diameter and thickness of the
attachment part used must comply with the
dimensions of the power tool. Incorrectly
dimensioned accessory tools cannot be suffi-
ciently shielded or controlled.
GB │ IE │
19 ■