Video Connections; Component Video Jacks; S-Video Jack; Composite Video Jack - Yamaha DVD-S559MK2 Bedienungsanleitung

Connections

Video connections

If your AV receiver has video output jacks,
connect your receiver and then your TV
so that you can use one TV for several
different video sources (LD, VCR, etc.) by
simply switching the input source selector
of your receiver.
This unit has four types of video output
jacks. Use the one that corresponds to the
input jacks of the component to be
connected.
This unit
P P
Y
R B
<A>
P
P Y
B
R
P /C P /C
R R B B
COMPONENT
VIDEO IN
AV receiver
VIDEO COMPONENT
OUT VIDEO OUT
VIDEO COMPONENT
IN VIDEO IN
Component video jacks <A>
Component video connections achieve
high fidelity color reproduction than S-
video connections by transmitting video
signals on separate wires for luminance (Y:
green) and chrominance (P
Connect VIDEO OUT - COMPONENT
(Y, P /C , P /C
B B R
component input jacks of your AV receiver
and then to those of your TV using a
commercially available component cable.
Observe the color of each jack when you
make connections.
8
En
Video pin cable
(supplied)
<B> <C>
V
S
Y
S VIDEO VIDEO
INPUT INPUT
S VIDEO
OUT
S VIDEO
IN
: blue, P
B
) jacks of this unit to
R
If your receiver does not have component
output jacks, you can achieve a better
video image by connecting the component
output jacks of this unit directly to the
component input jacks of your TV.
Note:
– You need to set "COMPONENT" to "YUV"
(see "Switching the YUV/RGB" on
page 28).
S-video jack <B>
S-video connections achieve a clearer
picture than composite video connections
by transmitting video signals on separate
wires for luminance (Y) and chrominance
(C).
Connect VIDEO OUT - S VIDEO jack of
this unit to S-video input jack of your AV
receiver and then to that of your TV using
<D>
a commercially available S-video cable.
Composite video jack <C>
Connect VIDEO OUT - VIDEO jack of this
unit to video input jack of your AV
receiver and then to that of your TV using
the supplied video pin cable.
SCART terminal <D>
If your TV has only a terminal for video
input, you can connect the TV directly to
this unit.
Connect AV terminal of this unit to
SCART input terminal of your TV using a
commercially available SCART cable.
Note:
– Ensure that the "TV" indication on SCART
cable is connected to the TV set and "DVD"
: red).
R
indication on SCART cable is connected to
this unit.