Yamaha DVD-S559MK2 Bedienungsanleitung Seite 40

Troubleshooting
Problem
No audio at digital output
Disc does not play
Picture freezes
momentarily during
playback
This unit does not respond
to the remote control
Buttons do not work
This unit does not respond
to some operating
commands during playback
This unit cannot read CDs/
DVDs
Menu items cannot be
selected
Unable to turn on or off a
progressive scan
No sound during DivX
movies playback
36
En
– Check the digital connections.
– If you are playing a DTS source, check that your receiver can decode
DTS and "DIGITAL OUTPUT" is set to "ALL" (see page 24).
– If you are playing an MPEG-2 source, check that your receiver can
decode MPEG-2. Otherwise, make sure "DIGITAL OUTPUT" is set
to "PCM ONLY" (see page 24).
– Check that the audio format of the selected audio language matches
your receiver capabilities.
– The CD-R/RW, DVD+R/RW/R DL and DVD-R/RW/R DL must be
finalized.
– Check that the disc label is facing up.
– Check that the disc is defective by trying another disc.
– If you have recorded a JPEG, MP3 or WMA disc yourself, check that
your disc contains at least 10 JPEG picture files or 5 MP3/WMA music
tracks.
– For MP3/WMA files, check that the sampling rate and bit rate are
compatible. For JPEG files, check that the resolution is compatible
(see "Notes about discs/content format" on page 3).
– Check the region code (see "Region codes" on page 3).
– Check the disc for fingerprints/scratches and clean it with a soft cloth
wiping from center to edge.
– Aim the remote control directly at the remote control sensor on the
front panel.
– Reduce the distance of the remote control from this unit.
– Replace the batteries in the remote control.
– Reinsert the batteries with their polarities (+/– signs) as indicated.
– To completely reset this unit, unplug the AC cord from the AC outlet
for 5-10 seconds.
– Operations may not be permitted by the disc. Refer to the
instructions of the disc jacket.
– Use a commonly available CD/DVD lens cleaner to clean the lens
before sending this unit for repair.
– Press STOP (9) twice on the remote control before selecting Setup
Menu.
– Depending on the disc availability, some menu items cannot be
selected.
– Check that the output of the video signal is switch to "YUV" (see
"Switching the YUV/RGB" on page 28).
– The audio code may not be supported by this unit.
Solution