Monitor Relay Programming - Agilent Technologies Turbo-V 300 ICE serie Bedienungshandbuch

17 Technical Information
Use
N
1
Where:
XX = indicates the rotational speed (53 KRPM for high speed, or 24
KRPM for low speed).

Monitor Relay Programming

The display shows:
H
S
Where:
XXKRPM = is the switch point of relay S1 at the preset turbopump
speed, adjustable from 00 to 56 KRPM. The speed threshold will
condition the S1 operation (see the following cycle diagram] and it is
factory-set to 53 KRPM.
The speed threshold will condition the S2 operation (see the
following cycle diagram] and it is factory-set to 24 KRPM.
Pump Shutdown
Press the front panel STOP push-button or remove the remote signal;
the power from the turbopump will be removed and the pump will
begin to slow down.
248/260
After the run up time and when the normal rotational speed is
reached, the display will be as follows, even if any previous
display selection was made, and the normal condition has been
reached.
O R M A
2 X X
. S .
E T T I
Turbo-V 300 ICE Controller User Manual / 87-900-902-01 (M)
L O P E
K R P M
T H R E S
N G ; X
R A T I O
H J H
H O L D
X K R P M
N
S