General Information - Agilent Technologies Turbo-V 300 ICE serie Bedienungshandbuch

16 Instructions for Use

General Information

General Information

This equipment is intended for use by professionals. The user should
read this instruction manual and any other additional information
supplied by Agilent before operating the equipment. Agilent will not
be held responsible for any events occurring due to non-compliance,
even partial, with these instructions, improper use by untrained
people, non-authorized interference with the equipment or any
action contrary to that provided for by specific national standards.
The Turbo-V 300 ICE series controllers are microprocessor-
controlled, solid-state, frequency converters with self-diagnostic and
self-protection features.
The controllers drive (within ten steps) the Turbo-V 300 ICE pump
during the starting phase by controlling the voltage and current
respect to the speed reached by the pump. They incorporate all the
facilities required for the automatic operation of the Turbo-V 300 ICE
pump series.
Remote start/stop commands, pump status signals, forepump
start/stop commands, interlock control signals (for pressure switch,
water flow switch), heater jacket control signals, flow meter control
signals and purge valve management signals are provided via
auxiliary connectors. The following paragraphs contain all the
information necessary to guarantee the safety of the operator when
using the equipment. Detailed information is supplied in the
appendix "Technical Information".
194/260 Turbo-V 300 ICE Controller User Manual / 87-900-902-01 (M)