Agilent Technologies Turbo-V 300 ICE serie Bedienungshandbuch Seite 238

17 Technical Information
Use
The Heater Jacket automatically switches to OFF when the controller
is in the Failure State.
H
S
Heater jacket operating temperature selection. The range is 40-90 °C,
set to 65 °C by default.
T
Detection of the pump's lower bearing temperature. OFF will always
be indicated if there is no sensor on this bearing.
and then:
S
S
where: XXX = YES or NO.
If YES is selected, the Soft Start mode allows the pump to rump-up
the Normal speed within ten steps.
When NO is selected, the Soft Start mode is deselected and the rump-
up of the pump will be done within 180 seconds.
The controller is factory set to YES.
The Soft Start mode may be deselected/selected only when the pump is
NOTE
stopped.
238/260
Press the PUMP CURRENT push-button and the display shows:
E A T J
E T T I N
Press the PUMP CURRENT push-button and the display shows:
L O W E R
2 S E N
O F T S
E L E C T
Turbo-V 300 ICE Controller User Manual / 87-900-902-01 (M)
A C K E T
G : X X
B E A R
S O R :
T A R T
I O N :
T E M P
° C
I N G
O F F
M O D E
X X X