Scalding hazard! Use the appropriate insulating devices to move the water and steam wands.
After positioning a container under the dispensing nozzle, the product can be dispensed in two ways:
1
With the DOSE KEYS 1 and 2.
Scalding hazard! Use the appropriate insulating devices to move the water and steam wands.
Dispensing with the Turbosteam selector (13)
1
Use the selector (13) knob to select the
type of frothed milk from the four available
settings (TS1 ÷ TS4).
Steam dispensing with knob control (20)
1
20
9
10. Hot water dispensing
2
In CONTINUOUS mode, using the
START key.
11. Steam dispensing
2
13
The type of frothing is displayed on the
touch screen.
Insert the steam dispensing
wand (9) in a suitable container.
Turn the steam knob (20)
clockwise to start dispensing
and counter-clockwise to stop
it.
The bar below the water buttons
indicates the temperature of the water:
longer bar = higher temperature.
3
Press the selector (13) to start dispensing.
Once the set temperature is reached, the
steam will stop automatically.
Note: At the conclusion of each steam dispensing phase,
clean the inside of the steam nozzle as follows:
Turn the nozzle towards the cup tray and carefully
activate steam dispensing at least once.
8 EN
English
13
English