Rear Brake; Brake Disc Thickness Control; Check The Level Of The Rear Brake Fluid; Restoring The Level Of The Rear Brake Fluid - Beta Motorcycles ALP 200 Bedienungsanleitung

4
BRAKE DISC THICKNESS
CONTROL
Periodically verify disc condition. In case
signs of damage , veins, or deformations
are present, proceed with replacement.
Verify disc thickness. The minimum thick-
ness is engraved on the disc.
Once the limit is in proximity or has been
reached, proceed with brake disc replace-
ment.
For replacement, contact an authorised
Betamotor after-sales service centre.

REAR BRAKE

CHECK THE LEVEL OF THE REAR
BRAKE FLUID
Check the level of the brake fluid through
sight 1. The level of the fluid should never
2
1
fall below the mark in the sight.
RESTORING THE LEVEL OF THE
REAR BRAKE FLUID
To restore the oil level, top up by means
of oil filler cap 2.
Use the liquid indicated on page 16 in
the "Recommended lubricants and liquids"
table.
WARNING:
The brake fluid is extremely corrosive. Take
care not to spill it on the paintwork.
EN
45