Comunello LIMIT 500 ONE Installations- Und Gebrauchsanleitung Seite 40

ENC MOT1 +: Operator 1 Encoder Power Input
ENC MOT1 GND: Operator 1 Encoder Common Input
ENC MOT1 E: Operator 1 Encoder Signal Input
CN8
8K2-ANT 8K2: 8k2 stop input
8K2-ANT GND: Common input (8k2 and Antenna)
8K2-ANT ANT+: Antenna Input
CN9
BUS: BUS line input for accessories
FUSES
F1: T3.15A 250V
F2: T15A 250V
F3: T3.15A 250V
• Connection of "Y" type power cable.
BUS CABLE TO CENTRAL POINT CONNECTION
BUS CASCADE CONNECTION
ACCESSORY ADDRESS ASSIGNMENT (BUS LINE)
The ONE control unit requires the use of ONE accessories connected
exclusively via digital (BUS) line with 2 non-polarised wires. Each accessory
(flashing light, photocells RX and TX, key switch, I/O board, etc.) must be
connected with only two wires (BUS line terminals) to the control unit. Both
the power supply and digital commands to control the accessories transit
on the BUS line.
Each accessory of the same family connected to the BUS line must be
identified by a UNIQUE numeric ID (different from all other accessories
of the same type). The ID of each accessory is set through the DIP-
SWITCHES accessible on the board:
40
COMUNELLO ®Copyright 2015 - All right reserved
Dip switch ID
DART
INTERFACE I/O
Dip switch ID
The ID assignment logic is as follows:
DIP1 = OFF
ON
DIP2 = OFF
1 2 3
DIP3 = OFF
DIP1 DIP2 DIP3
DIP1 = ON
ON
DIP2 = OFF
1 2 3
DIP3 = OFF
DIP1 DIP2 DIP3
DIP1 = OFF
ON
DIP2 = ON
1 2 3
DIP3 = OFF
DIP1 DIP2 DIP3
DIP1 = ON
ON
DIP2 = ON
1 2 3
DIP3 = OFF
DIP1 DIP2 DIP3
DIP1 = OFF
ON
DIP2 = OFF
1 2 3
DIP3 = ON
DIP1 DIP2 DIP3
DIP1 = ON
ON
DIP2 = OFF
1 2 3
DIP3 = ON
DIP1 DIP2 DIP3
DIP1 = OFF
ON
DIP2 = ON
1 2 3
DIP3 = ON
DIP1 DIP2 DIP3
DIP1 = ON
ON
DIP2 = ON
1 2 3
DIP3 = ON
DIP1 DIP2 DIP3
SETTING THE ACCESSORY OPERATION (MODE)
Each accessory can be set according to its type of OPERATION (e.g.:
photocell active on closing, I/O board with INDICATOR LIGHT output, etc.);
this type of configuration can be done directly on the board by setting the
corresponding DIP-SWITCH:
Dip switch ID
INDEX
SWIFT
Dip switch ID
ID = Accessory no.1
ID = Accessory no.2
ID = Accessory no.3
ID = Accessory no.4
ID = Accessory no.5
ID = Accessory no.6
ID = Accessory no.7
ID = Accessory no.8