Kalor SLIM IDRO 16 Bedienungsanleitung Seite 50

This general cleaning should be carried out at the end
of the season in order to facilitate the general removal
of all residues of combustion, without waiting too long,
because with time and humidity these residues can
become compacted. Check the seal of the ceramic fiber
gaskets on the door of the thermostove.
Then clean the flue system especially near the fittings to
"T" and any horizontal sections.
For your safety, the frequency of cleaning
the smoke discharge system must be
determined on the basis of how the
thermostove is used.
In case of failure or inadequate cleaning of the heater
may have function problems such as:
• poor combustion
• blackening of the glass
• clogging of grate with accumulation of ash and pellets
• ash deposit and excessive deposits on the heat ex-
changer resulting in poor performance.
The check of electromechanical components must be
performed only by qualified personnel with technical
knowledge of electricity and combustion.
We recommend that an annual maintenance service
is carried out, preferably under a programmed service
contract. The essential part of this service is a visual and
functional check on the following components:
• reduction motor
• smoke expulsion fan
• smoke sensor
• ignition sparkplug
• resettable pellet thermostat
• room temperature sensor
• pressostat
• motherboard
• fuse protecting panel - motherboard
These operations must be performed by a
qualified technician, or the user who will
take responsibility in the event of damage
during maintenance.
Perform this maintenance heater cold and in the
absence of electricity. If such maintenance is
performed by an authorized service center is the
responsibility of the customer.
Surface cleaning
The thermostove is a product by heating, presents the
external surfaces particularly hot.
For this reason, we recommend extreme caution when
operating in particular:
• Do not touch the thermostove body and the various
components, do not approach the door, it could cause burns;
• Do not touch the exhaust fumes;
• Do not perform any type of cleaning;
50
• Do not dump the ashes;
• Do not open the ash tray;
• Be careful that children do not come close.
All cleaning of all parts must be carried out with the stove
completely cold and the plug disconnected.
To clean the surfaces, use a rag dampened with water or
with water and a neutral detergent.
L'uso di detergenti o diluenti aggressivi
portano al danneggiamento delle superfici
della stufa. Prima di utilizzare qualunque
detergente si consiglia di provarlo su un punto non
in vista o contattare il Centro Assistenza Autorizza-
to per consigli in merito.
Warnings for cleaning
All cleaning of all parts must be carried out with the stove
completely cold and the plug disconnected.
Before effecting any maintenance operation or cleaning
on the stove, take the following precautions:
• be sure that all parts of the stove are cold
• be sure that the ashes are completely cold;
• be sure that the general switch is in the "OFF" position;
• be sure that the plug is pulled out of the socket to avoid
accidental contact;
• Once the maintenance phase is completed check that
everything is in order as per before the intervention (the
brazier is placed correctly).
Follow carefully the following cleaning
instructions.
instructions could create problems with
the operation of the thermostove.
Any kind of tampering or unauthorized substitution of
non-original of the thermostove can be hazardous to the
safety of the operator and relieves the manufacturer from
any civil or criminal liability. Use only original spare parts.
Replace a worn before failure promotes the prevention of
injuries resulting from accidents caused by the sudden
failure of the components.
After 1300 hours of operation of the
heater will appear on the lower display
the word "S E RV", please contact your
Authorized Service Center for cleaning and
routine maintenance.
Failure to follow these