Kalor SLIM IDRO 16 Bedienungsanleitung Seite 42

Water Characteristics
The characteristics of the water used to fill the system are
very important to prevent the build-up of mineral salts and
the formation of incrustations along the pipes, in the boiler
and in the heat exchangers.
Therefore, please get your plumber's advice concering:
• Hardness of water circulating in the system, to prevent
problems of incrustation and limescale, especially in the
domestic water heat exchanger (>25° French).
• Installation of a water softener (if water hardness > 25°
French).
• Filling the system with treated water (demineralised).
If you have very extensive system, with a large amount of
water, or which require frequent refilling, it is recommended
the installation of water softening system. It 'should
be noted that the encrustations drastically reduce
performance because of their low thermal conductivity.
Heating timer-thermostat
The heating timer-thermostat function is used to program the pellet boiler stove to automatically turn on and off within
a period of one week.
To access programming, hold down button
by pressing button several times and referring to the table below, the stove can be programmed according to your
needs. Press button to exit the programming phase at any time.
These are the heating timer-thermostat parameters:
Parameter Description
H. timer-thermostat
UT01
enabling and disabling.
Day of the week setting
UT02
Current hour setting
UT03
Current minutes setting
Technical parameters
UT04
setting
Thermostove first start-up
UT05
time adjustment
Thermostove first shut-
UT06
down time adjustment
Week day selection, first
UT07
time activation
Thermostove second
UT08
start-up time adjustment
42
for around three seconds, "U T0 1" will be shown on the upper display:
Programmable
values
OFF; Day 1, ...,Day7
From 00 a 23
From 00 a 60
Reserved
From 00:00 to 23:50 with
10 minute steps
From 00:00 to 23:50 with
10 minute steps
Between on/off for days
from 1 to 7
From 00:00 to 23:50 with
10 minute steps
freshwater (0-12)
water medium (12-20)
hard water (20 - 30)
very hard water (over 30)
Parameter Description
Thermostove second
UT09
shutdown time adjustment
Week day selection,
UT10
second time activation
Thermostove third start-up
UT11
time adjustment
Thermostove third
UT12
shutdown time adjustment
Week day selection, third
UT13
time activation
Thermostove fourth start-
UT14
up time adjustment
Thermostove fourth
UT15
shutdown time adjustment
Week day selection, fourth
UT16
time activation
Programmable
values
From 00:00 to 23:50 with
10 minute steps
Between on/off for days
from 1 to 7
From 00:00 to 23:50 with
10 minute step
From 00:00 to 23:50 with
10 minute step
Between on/off for days
from 1 to 7
From 00:00 to 23:50 with
10 minute steps
From 00:00 to 23:50 with
10 minute steps
Between on/off for days
from 1 to 7