Kalor SLIM IDRO 16 Bedienungsanleitung Seite 48

Cleaning exchanger - stove off
Fouling act as insulation and the thicker they are, the
lower the heat that is transmitted to the water and to the
structure generally. Therefore very important to perform
the cleaning of the tube bundle, said exchanger also, to
prevent the fouling of the same and prevent clogging and
jamming of the cleaning
5-6 times the lever so that the springs can remove the
soot deposited on the pipes.
Check every 2/3 days
Cleaning the ash collection compartment.
Clean and empty the ash tray being careful with hot ash.
The ash must be completely cold for a vacuum cleaner to
be used to remove it. Only if the ash is completely cold,
you can also use a canister vacuum cleaner suitable for
picking up particles of a certain size.
Cleaning ash and combustion chamber including the
spark plug lead
Cleaning the glass
For cleaning the ceramic glass, the use of a dry brush
is recommended, or if it is very dirty, the special spray
detergent, applying a small quantity then cleaning with a
cloth.
Do not use abrasive products and do not
spray the cleaning product on the glass of
the painted parts or on the gaskets of the
fire door (ceramic fibre cord).
Cleaning of stainless steel and satin-finish surfaces
Normally these surfaces do not need to be treated, but
if they do, avoid cleaning them with abrasive materials.
For surfaces in stainless and satin brushed steel we
recommend cleaning with a paper towel or a clean dry
cloth moistened with a detergent based on non-ionic
surfactants (<5%) A spray glass cleaner may be used.
Avoid contact with skin cleanser and eyes.
In case this happens, sprinkle with plenty
of water and contact the nearest medial
center.
48
device. Pull and push quickly for
Cleaning of painted pats
Do not clean the painted parts with wet rags when the unit
is in operation or hot to prevent thermal shock to the paint
which may cause it to detach.
Do not use abrasive or aggressive products or materials.
Clean with damp cotton or paper towels.
The silicon paints used by manufacturer possess technical
characteristics that make them resistent to very high
temperatures.
There is however a physical limit (380° - 400°) beyond
which the paint begins to fade or (over 450°) to vitrify; it
may then flake and detach from the steel surface.
If this happens, it means that temperatures have been
reached that are far above those at which the unit should
operate properly.
Do not use abrasive materials or harsh.
Clean with damp cotton or paper towels.
Check every 3-4 sack of pellets burned
Clean bottom ash from the fallen debris during
You can access the ash pan by loosening the two wing
nuts that hold the drawer
empty and clean the wall and only the corners with a
suction device or with dedicated
drawer and tighten the two knobs being careful to restore
the tightness, very important during operation.
With a dry clean also the combustion chamber.
operation.
inspection. Remove the tray,
tooling. Then mount the