Kalor SLIM IDRO 16 Bedienungsanleitung Seite 41

Directions for use
If the installation of the thermostove provides interaction
with another existing system complete with a heater
(gas boiler, gas boiler, oil boiler, etc..) consult qualified
personnel who can then answer the compliance of the
system, as envisaged by the law in force.
Flushing the system
In accordance with the UNI-CTI 8065 is strongly
recommended to wash the entire system before
connecting it in order to get rid of residues and
deposits. After flushing the system to protect it against
corrosion and deposits, it is recommended the use of
inhibitors.
Upstream from the stove, always install shutters so as
to disconnect it from the plumbing system should it be
necessary to move it, or when it requires routine and/or
special maintenance. Connect the stove using hoses so
that the stove is not too strictly connected to the system,
and to allow slighht movement.
These are as helpful as the supply and return piping
system if the heating system is on a higher floor than the
boiler.
The exhaust pipe pressure is connected temporarily to a
carafe or a funnel to avoid, in case of overpressure, that
the water gush bathrooms and the structure and the floor.
Filling the thermostove funding of sanitary kit
Once all the water connections, proceed to check pressure
seal by filling the thermostove. During this operation, any
air in the system is released from the automatic vent
valve.
The filling pressure of the system when cold must be
1 bar.
During operation, if the system pressure drops (due to
evaporation of dissolved gases in the water) to values
lower than the minimum indicated above, the user must
use the filling tap to bring the pressure back up to its
normal pressure.
For proper operation of the stove when hot, the pressure
VE N TIN G
in the boiler must be 1,5 bar.
SELF
VALVE
STOPPER
BLOCKED
LOOSE
STOPPER
ONE TURN
41