Kalor SLIM IDRO 16 Bedienungsanleitung Seite 49

Shutting the thermostove down
In the period when the thermostove is out of use it
must be disconnected from the electricity mains. For
greater safety, especially if there are children around, we
recommend removing the power cable from the rear of the
thermostove.
Before placing the thermostove in storage, you should
remove all pellets from the hopper with a vacuum cleaner
with a long extension. If the fuel is left in the hopper, it may
get damp, stick together, and be difficult to light at the
beginning of the next season.
If pressing the main switch (located on the back of the
stove) does not make the control panel display light up, it
could mean that the service fuse needs replacing.
On the rear of the stove there is a fuse holding
compartment which is located underneath the supply
socket. With a screwdriver open the cover of the fuse
holding compartment, and replace the fuse if necessary
(3,15 AT delayed type). Plug the unit back in and press the
main switch.
CLEANING BY THE TECHNICAL
Check every year
Compartment ventilation flue gas cleaning
Remove the fixing screws and remove the smoke fan for
cleaning of the same. Perform the task with the greatest
care not to bend the fan blades.
Clean flue
Clean the flue system especially near the fittings to "T",
curves and any horizontal sections. Is necessary to check
and remove any deposit of ash and soot before the same
clogging the passage of smoke.
Cleaning the exchanger
Lift the top of the thermostove where present the entire
top. Otherwise, open the fuel filler flap pellet (on the right
side of the thermostove) and the door smoke (on the left
side). Then unscrew the four screws that secure the dis-
play to enter the tube bundle.
Then unscrew the 10 screws on the cover and the two
items above the door and hidden from the front panel.
Remove the corn rod that supports the springs and re-
move it as shown in the image below. Do this by removing
a spring at a time making sure it does not fall within the
tube bundle.
Repeat the same operation
with the other three springs
present. Now the upper sec-
tion to the heat exchanger is free from any encumbrance
so as to allow a perfect cleaning.
Once a year is also recommended to clean the upper
compartment of the exchanger. To make a proper cleaning
is recommended to suck the ash, remove all horizontal
joints with a screwdriver, then again suck the ash.
Following the cleaning of the upper compartment of
the exchange section, store the upper closure cover.
This cover must be closed, as well as with normal screws,
with webbing in ceramic fiber rope to ensure the watertight
closure of the thermostove.
49