First Ride - Pendix Montageanleitung

32 Nm +/- 2 Nm
Now screw on the right-hand pedal in clock-
wise motion to a torque of 35 Nm +/- 2 Nm.
35 Nm +/- 2 Nm
You have now completed assembly of the Pendix.
Before your first bike ride, check the chain
line. Also check for correct and safe gear
change function. The chain wheels may have
a slightly different position than before, this
means a new adjustment of the gear change
function may be necessary. Only ride if gears
change without difficulty.
Make sure the crank and the chain move
without contact at all gear levels inside the
chain guard.
Gear changing systems are safety-relevant
components! Leave all work on gear chan-
ges to your bicycle specialist! All mechanical
and adjustment work which is not carried out
professionally by a specialist makes riding
your bicycle dangerous! When adjustments
are faulty, the chain of your bicycle can drop
off and cause accidents through falling. If you
are not sure, please always contact a bicycle
specialist who can make these necessary
adjustments for you in a proper way.

7. First ride

After completing installation and switching on the Pen-
dix system for the first time, the motor control system
runs an automatic calibration. Thus, when switching
on for the first time, the calibration mode is indicated
by a blinking green light on the LED display. To ca-
librate, please ride your bicycle during this blinking
phase for at least 300 m (about 1,000 feet). In the be-
ginning, the drive system (motor) is not yet supporting.
Try to ride as steady as possible keeping to the same
speed. As soon as the motor has finished calibrating
successfully, the LED display shows a permanent
green light and the motor is supporting.
EN
31