Kaiser EH Serie Gebrauchsanweisung Seite 48

1
48
2
EN
Errors, possible reasons, advices
If the temperature sensor fails, error
code ER1 will appear on the display,
the door is locked and the oven contin-
ues to heat up:
• Press and hold the knob 1 for 5 sec-
onds to turn off the power.
You have to wait until the door is un-
locked. Remove food from the oven.
Then the device must be repaired in a
service center.
If the temperature reading does not
change during the heating for more
than 10 minutes, the display will show
the error code Er2. When the temper-
ature exceeds 300 °C, the door is
locked; when the device is turned on, if
the temperature is above 300 °C, the
door is locked.
• Press buttons 1 and 2 simultane-
ously for 2 seconds to eliminate the
problem (the door will open).
The oven door is not locked, the delay
is 10 seconds. The error code Er3
flashes on the display. A beep sounds.
• Select the F-10 self-cleaning function
and confirm unlock.
The oven door is locked. The error
code Er4 flashes on the display. A
beep sounds.
• Turn off power to the device. Recon-
nect power.
IMPORTANT!!!
If despite of the recommendations the
problems persist – contact the Cus-
tomer service.