Supplementary Notes; Original Accessories/Auxiliary Equipment; Before Use; Milling Cutter Set/Areas Of Use - Parkside POF 1200 D3 Originalbetriebsanleitung

Supplementary notes

■ The maximum speed of the milling tool used
must be at least as high as the maximum
speed specified for the power tool. Acces-
sories which rotate faster than the maximum
permissible rate can be destroyed.
■ Cutters or other accessories must fit exactly
into the collet chuck (shank diameter 6/8 mm)
of your power tool. Milling tools which do not
fit precisely into the collet chuck of the power
tool will rotate unevenly, vibrate severely and
can lead to a loss of control.
■ Always switch on the electrical power tool
before applying it to the workpiece. Otherwi-
se, there is a risk of a kickback if the accessory
tool gets caught in the workpiece.
■ Keep your hands clear of the milling area and
the milling tool. Hold the auxiliary handle or
motor housing with your other hand. If both
hands are being used to hold the milling machine,
neither can be injured by the milling cutter.
■
Never mill over metal objects, nails or screws.
The milling cutter can be damaged and it can
lead to increased vibrations.
■
Use a suitable detector to locate hidden utility
lines or consult your local utility company.
Contact with electrical lines can cause fires or
electric shocks. Damage to a gas pipeline can
lead to an explosion. Drilling into a water pipe
can cause damage to property.
■ The maximum speed indicated on the tool must
not be exceeded.
■ Tools with visible cracks must be discarded.
│ GB │ MT
■ 48
Original accessories/auxiliary
equipment
■
Only use the accessories and additional
equipment that are specified in the operating
instructions and are compatible with the
appliance.

Before use

Milling cutter set/areas of use

Original accessories included in delivery:
For profiling:
Rounding cutter Ø 22 mm / R 6.3 mm
Profile cutter Ø 25 mm / R 4 mm
Chamfer milling cutter Ø 22 mm / R 6.3 mm
V-slot milling cutter Ø 12,7mm / angle 90°
For linking:
Slotting cutter Ø 6 mm
Slotting cutter Ø 12 mm
NOTE
► If the ball bearing of a milling cutter has
become loose, tighten it with the hex key
supplied with the cutter set.
POF 1200 D3