7
Prozessdaten-Transfer
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Port-Mapping im »Engineer«
Das Port-Mapping im »Engineer« kann automatisch über eine auszuwählende Schnittstelle
erfolgen:
• POWERLINK MN/CN
• CAN on board
• Vom System festgelegt
So wählen Sie die Schnittstelle für die automatische Vergabe des Port-Mappings:
1. Unter der Registerkarte Prozessdatenobjekte die Schaltfläche "Gehe zu Applikation"
betätigen.
2. Unter der Registerkarte Ports der Applikation die Schaltfläche "Schnittstelle für
automatische Vergabe ..." betätigen und die gewünschte Schnittstelle auswählen.
Lenze · Kommunikationsmodul E94AYCEP (POWERLINK) · Kommunikationshandbuch · DMS 6.0 DE · 02/2014 · TD17
44