The Right Place For Mounting; Tools Required; Before Mounting - LIVARNOLUX LSLB 30 A1 Bedienungs- Und Sicherheitshinweise

6.1 The right place for mounting

Select a location carefully and prepare well before mounting.
 Arrange all the individual parts, tools required and fittings tidily so everything is ready to hand.
 The LED emitter must only be mounted on stable surfaces such as walls.
 The power supply must be via the building's electrical circuit.
 Do not mount the LED emitter above a heat source or in the immediate vicinity of other light sources.
When choosing the right place for mounting, please also note the illustrations [D and E] on the cover
page.
 Select the location so that the LED emitter is protected against wind, rain and dirt.
 Find out in advance what fittings are suitable for the location you have chosen. Suitable fittings for
mounting on concrete are provided.

6.2 Tools required

The following tools are not supplied. This list is a guide only. The actual tools you will require depend on
the individual location.
 Ladder
 Voltage tester
 Spirit level, folding rule, pencil
 Drill and drill bits
 Phillips screwdriver, flat screwdriver
 Open-ended spanner, combination pliers, wire cutters

6.3 Before mounting

DANGER! The unit must only be mounted by an authorised electrical engineer! The power
supply must be via the building's electrical circuit.
The power must be switched off during the mounting process!
When drilling holes, make sure there are no cables in the walls.
 Before mounting the LED emitter, make sure you are familiar with all its individual parts and read and
observe the instructions and diagrams in these operating instructions.
 Make sure that the cable to which the LED emitter is to be connected is not live. To do this, remove the
fuse for the relevant power circuit or switch the circuit breaker to the "0" position in your fusebox.
 Make sure that you also test that the cable is not live using a voltage tester!
LIVARNO LUX LSLB 30 A1
English - 7