Safety Advice Concerning Batteries / Rechargeable Batteries; Initial Use; Adjusting The Reflector - LIVARNOLUX 14121906L Bedienungs- Und Sicherheitshinweise

Safety / Initial use
Disconnect the lamp from the mains before
assembly, dismantling or cleaning.
To save energy, disconnect the lamp from the
mains as soon as it is fully charged.
Safe working
Position the lamp so it is protected from moisture
and dirt.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Do not cover the lamp with objects. Excessive
heat can result in fire.
Do not look into the LED from a close distance
during operation.
Do not look into the LED with an optical instrument
(e.g. magnifier).
Safety advice concerning
batteries / rechargeable
batteries
DANGER TO LIFE!
Keep the batteries / rechargeable batteries out
of the reach of children. If accidentally swal-
lowed seek immediate medical attention!
EXPLOSION HAZARD!
Never recharge batteries that are not recharge-
able. Do not short-circuit batteries (or recharge-
able batteries) and / or do not open! The
battery may overheat, ignite or explode.
Never throw batteries / rechargeable batteries
into fire or water!
Do not exert mechanical loads on batteries /
rechargeable batteries!
Risk of battery leakage
Avoid extreme conditions and temperatures
which may affect the batteries / rechargeable
batteries, e.g. on radiators/ in direct sunlight.
Avoid contact with the skin, eyes and mucous
membranes! In the event of contact with battery
acid, thoroughly flush the affected area with
14 GB/IE
plenty of clean water and seek immediate
medical attention!
WEAR PROTECTIVE GLOVES!
Exhausted or damaged batteries / rechargeable
batteries can cause caustic burns upon contact
with the skin. To avoid this, always wear suitable
protective gloves!
This product features a built-in rechargeable
battery which cannot be replaced by the user.

Initial use

Take the lamp out of the package and remove
all packaging materials.
Insert the USB micro-B-plug
USB micro-B port
2
Insert the USB plug
the plug adapter
7
Plug the plug adapter
installed socket.
Allow the lamp to charge fully.
Plug the plug adapter
Remove the USB cable
supply and lamp.
Your lamp is now ready to use.
Adjusting the reflector (Fig. B)
Only adjust the position of the reflector
the lamp is turned off and has cooled down.
Note: Ensure the lamp is stable (fig. E).
Adjust the reflector
ATTENTION:
Do not twist the movable lamp part around
itself (fig. C).
Do not bend the movable lamp part more than
180° (fig. D).
Excessively bending or twisting the lamp will
damage the electrical components of the lamp.
into the lamp's
10
.
into the USB socket of
8
.
into a properly
7
from the socket.
7
from the power
9
if
1
to the desired position.
1