Intended Use; Package Contents - LIVARNOLUX LSLB 30 A1 Bedienungs- Und Sicherheitshinweise

1. Intended use

This LED emitter is not intended for commercial use. It is suitable for inside and outside use. The device
fulfils all relevant norms and standards relating to CE conformity. Any modifications to the LED emitter
other than recommended changes by the manufacturer may result in these standards no longer being met.

2. Package contents

 LED emitter LIVARNO LUX LSLB 30 A1
 Fitting materials (2 x screws and 2 x wall plugs)
 Operating instructions with safety instructions
These operating instructions have a fold-out cover. On the inside of the cover is a diagram of the LED
emitter with the components numbered (figures A to C). The meanings of the numbers are as follows:
Twist joint
1
Pitch joint
2
Reflector
3
Sensor housing
4
Movement sensor
5
Screw
6
Mounting plate
7
Unlock button
8
Screw terminal
9
Power cable (not included in the package / domestic power lines)
10
TIME controller
11
SENS controller
12
LUX controller
13
Screw (2 units, for wall-mounting) - no picture -
14
Wall plug (2 units, for wall-mounting) - no picture -
15
LIVARNO LUX LSLB 30 A1
English - 3