Working Procedures; Dust Extraction - Parkside PBS 900 C3 Originalbetriebsanleitung

Working procedures

A light grinding pressure is sufficient:
■ Apply minimal pressure when grinding . The belt
sander's own weight is sufficient for a good
grinding result . In addition, working this way
helps to reduce the wear on the abrasive belt
and the surface of the workpiece will become
smoother .
Removal and surface:
■ The material removal rate and surface quality
are determined by the belt speed and grain
strength of the sandpaper (see also the section
"Selecting speed and abrasive belt") .
Grinding:
■ Place the appliance on the workpiece when
switched on and work at a moderate feed rate .
Guide the sander in parallel and overlapping
sanding motions over the workpiece . To avoid
unpleasant transverse grinding marks, always
sand in the direction of the grain .
After completing the task, lift the appliance from
the workpiece and then switch it off .
NOTE
► Always hold the appliance firmly with two
hands while working .

Dust extraction

WARNING! RISK OF EXPLOSION !
■ If there is an explosive dust/air mixture, you
must use a specially-designed extraction
device .
RISK OF FIRE DUE TO FLYING SPARKS!
Do not use dust extraction systems (dust col-
lector or vacuum cleaners) when grinding
metals .
■ Materials containing asbestos may not be pro-
cessed . Asbestos is a known carcinogen .
■ 30 │ GB │ MT
WARNING! RISK OF FIRE!
■ When working with power tools which
have a dust collector or can be connected
to a vacuum cleaner via a vacuum cleaner
adapter, there is a risk of fire! In unfavourable
conditions, e .g . when sparks are flying while
sanding metal or metal residues in wood,
wood dust in the dust collector (or the bag
of the vacuum cleaner) can spontaneously
ignite . This is a particular risk if the wood
dust is mixed with paint residues or other
chemicals and the workpiece has become hot
after being worked for a long time . Therefore,
do not allow the workpiece to overheat and
always empty the dust box or the dust bag
of the vacuum cleaner before taking a break
from work .
■ Ensure that your workplace is adequately
ventilated .
■ Observe the regulations applicable in
your country regarding the materials to be
worked .
■ Wear a dust mask.
Dust extraction with dust collector (see fig. C):
♦ Push the dust collector
nozzle .
Dismantling/removing the dust collector:
♦ Pull the dust collector
Dust extraction adapter (with reducer )
(see fig. C):
♦ Push the dust extraction adapter
extraction nozzle
ducer by pushing it onto the dust extraction
adapter .
♦ Push the hose from a suitable dust extraction
appliance (e .g . a workshop vacuum cleaner)
onto the dust extraction adapter
reducer if necessary .
onto the extraction
off the appliance .
onto the
. If necessary, use the re-
; use the
PBS 900 C3