Mounting The Adapter For External Extraction; Adjusting The Additional Handle; Working Procedures; Sanding - Parkside PWBS 180 B3 Originalbetriebsanleitung

Mounting the adapter for external
extraction
♦ Push the dust extraction adapter
extraction nozzle
♦ Connect an approved dust extraction system.
NOTE
► When sawing wood or other materials that
can create dusts that are hazardous to
health, always connect a suitable, certified
vacuum extractor appliance.

Adjusting the additional handle

The angle of the additional handle
adjusted to achieve a more favourable working
position for the guide hand in certain applications
(e.g. when grinding close to an edge).
♦ Loosen the two wing screws
additional handle
position.
♦ Retighten the wing screws

Working procedures

WARNING! RISK OF INJURY!
► Always remove the plug from the power
socket before working on the appliance.
► Wait until the appliance has come to a
standstill before putting it down.
The removal rate and the surface quality are deter-
mined by the selection of the sanding tool, the
preselected speed level and the contact pressure.
Only sanding tools that are in perfect condition
provide a good sanding performance and protect
the appliance.

Sanding

■ Hold the appliance firmly with both hands
when working and ensure that you have
secure footing.The appliance is guided more
safely with two hands.
♦ Connect your extraction system (internal or
external extraction).
■ 10 │ GB │ IE
onto the
.
can be
and tilt the
to the desired working
.
♦ For external suction:
If possible, work with the remote switch-off or
the automatic start/stop function of the vacuum
cleaner. The vacuum cleaner switches on auto-
matically and switches off again after a time
delay in order to remove the remaining dust
from the suction hose.
♦ Switch on the appliance, place it with the entire
sanding surface on the surface you are working
on and move it over the workpiece with
moderate pressure.
♦ To prolong the service life of the accessory tool,
ensure that you apply even pressure.
♦ Use of excessive pressure does not lead to a
greater removal rate, but rather to increased
wear of the accessory tool.
♦ Lift the appliance off the working surface.
♦ For internal extraction:
Let the power tool run for a few more seconds
to remove the remaining dust from the suction
hose .

Sanding close to the edge

If you are sanding close to the edge, you can
remove a hood segment
suction hood . This means that the accessory tool
you are using is closer to floor, wall and ceiling
edges as well as existing installations such as
pipes, and the adjacent surfaces can be precisely
machined.
Expect dust to develop during this work, as the
protective and suction hood
off.
♦ Pull the hood segment
protective and suction hood
♦ Work the surfaces close to the edge.
♦ Push the hood segment
hood until it locks into place.
of the protective and
is no longer closed
forwards out of the
.
back into the suction
PWBS 180 B3